Grid System modules
Clamp modules, single directional (GCS-)
In most cases, code format is GCS-Djn, where j corresponds to a jaw type (serrated, smooth, diamond). Also other jaw types are available.
- Dx1 modules are the shortest, with a jaw movement of max. 35 mm
- Dx2 possess a jaw movement of max. 85 mm
- Dx3 possess a jaw movement of max. 35 mm
While Dx1 and Dx2 modules can be installed in 4 directions on a standard 50x50 M12 platform (0,90,180 or 270 degrees) Dx3 modules can be installed in more positions such as 15,65 and 75 degrees in addition to previously mentioned.
Grid System riser blocks (GP-)
Riser block tabs that posses a M12 thread longer than 18 mm:s, can be also used directly on standard M12 grid platforms.
Riser blocks used in the Grid System can be built from different standard components. Riser blocks can be placed easily in almost any position on the grid platform. Height can be adjusted by combining suitable riser modules, adjusting the height with the M12 thread and finally machining if needed.
Please specify your needs and we will recommend you a suitable set!
Adjustable stopper modules (GS-)
Code format is GS-jAn, where j corresponds to a jaw type and n is a base type.
- xA1 modules are the shortest, with a jaw movement of max. 60 mm
- xA2 possess a jaw movement of max. 110 mm
- xA3 possess a jaw movement of max. 60 mm
While xA1 and xA2 modules can be installed in 4 directions on a standard 50x50 M12 platform (0,90,180 or 270 degrees) xA3 modules can be installed in more positions such as 27,45 and 63 degrees in addition to previously mentioned.
Grid System side guides
Some side guides for the Grid System can be built using the same components used for the riser blocks.
Additionally, there are modules to adapt spring guides (in the photo) to the Grid System side guide.
Grid System modules
As in every OK-VISE Fixturing Concept system, the basic modules in the Grid System are clamp, stopper, side guide and riser block modules. There are fixed and adjustable stoppers in the system, additionally single directional clamp modules share the same base module than adjustable stoppers.
Compared to fixed modules in the Grid system, with adjustable modules the place of the jaw can be moved in 2.5 mm steps.
If the difference in workpiece sizes is larger than the total movement of the jaw, then the module will be moved 50 mm to the next positioning hole location on the grid platform