OK-VISE® Fixturing Concept

As in every OK-VISE Fixturing Concept system, the basic modules in the Blank System are clamp, stopper, side guide and riser block modules.

To resist the clamping and machining forces, a pocket should be machined to the blank plate. Pictures of the pockets are available in the installation instruction.

In addition to the basic modules above, the generic components complementing our product range can be used in the Blank Fixturing System as well as in other OK-VISE fixturing systems.

 Code Dim.  STEP
KCD-DS1 icon pdf
KCD-DS2
KCD-DR1 icon pdf
KCD-DR2

In most cases, code format is KCD-sjn, where corresponds to a clamp size (B or D), j is a jaw type (Serrated, Smooth) and is a plate type.

kcd ds2 2KCD-DS2KCD-BR2KCD-BR2

 Code Dim.  STEP
 KS-R1 icon pdf
 KS-R2
 KS-R3

In most cases, code format is KS-Rx, where corresponds to a serrated jaw type and is a type.

ks r1KS-R1KS R2 2KS-R2

 Code Dim.  STEP
 KCS-DS1 icon pdf
 KCS-DR1 icon pdf
 KCS-DES1  
 KCS-BR3 icon pdf

In most cases, code format is KCS-sjn, where corresponds to a clamp size (B or D), is a jaw type (Serrated, Smooth) and is a frame type.

Almost all other jaw combinations are also available. For example, in KCS-DES1 model, E stands for a self-aligning jaw and S - for a smooth jaw.

KCS-DX modules recomended maximum clamp tightening moment is 70Nm. Maximim force is 30KN.

For extremely compact design, types like KCS-BR3 are recommended. Please note that in this case fixture plate must be machined also from the bottom side (see instruction).

kcs dr1 faKCS-DR1 kcs dt1 faKCS-DT1 KCS DES1KCS-DES1 kcs br3KCS-BR3

There are also "A" models that are optimized specially for robotic loading of workpieces, for KCS-DR1A.

 Code Dim.  STEP
KS-S1 icon pdf
KS-S2
KS-SO1

In most cases, code format is KS-Sx, where corresponds to a smooth jaw type and is a stopper type.

ks s1KS-S1ks so1 1KS-SO1

 Code Dim.  STEP
 KS-D1 icon pdf
 KS-D2
 KS-D3

In most cases, code format is KS-Dx, where corresponds to a diamond jaw type and is a base type.

ks d2KS-D2

 Code Dim.  STEP
 KG-1 icon pdf
 KG-2 icon pdf

In most cases, the code format is KG-n, where n is a guide type. Max tightening torque 30Nm.

KG 1KG-1KG 2KG-2

 Code Dim.  STEP
 KP-1 icon pdf

In most cases, code format is KP-n, where n is a type.

KP 1KP-1

 Code Dim.  STEP
 KS-R6 icon pdf

This stopper type is normally embedded 6 mm in the base plate 
Uses M6 bolt.

KS R6 400X300KS-R6