Tooling block system T1  

The T1  tower concept is based on clamping jaws that are fastened in column T-slots. Workpieces are clamped between a stop jaw and a clamping jaw; combi-jaws are also available.

Clamping forces are led from the jaws to the tower column by means of toothing. This makes movement of the jaw practically impossible and results in extreme repeatability of the machining process. The fine tolerance of the toothing facilitates fastening workpieces of any size.

Clamp jaws are available with single or twin clamp installations.
Both versions can be single-acting or double-acting.
A double-acting clamp jaw fastens two workpieces with a single clamp.

Two types of pull-down clamps can also be used.
The surface treatment is a special type of nitriding, complementing  the stylish design of the tower.

Dimensions

Tower colum heights 500...900 mm
Rail width 75 or 125 mm
Toothing resolution  3.5 mm
Adapter plate   DIN / JIS

Options

JS-1 Stop jaw

JC-1 Clamping jaw. Single installation, double acting

JC-3 Combi-jaw.
Double installation, single acting. Recommended rail width: 125 mm.